Real 350-501 are Uploaded by ActualTorrent provide 2021 Latest 350-501 Practice Tests Dumps.
All 350-501 Dumps and Implementing and Operating Cisco Service Provider Network Core Technologies Training Courses Help candidates to study and pass the Implementing and Operating Cisco Service Provider Network Core Technologies Exams hassle-free!
NEW QUESTION 67
Refer to the exhibit:
It the NetFlow configuration is updated to version 9, which additional piece of information can be reported"?
- A. flow sequence numbers
- B. BGP AS information
- C. IPv6 flow information
- D. IPv4 flow information
Answer: C
NEW QUESTION 68
Refer to the exhibit:
You are configuring an administrative domain implement so that devices can dynamically learn the RP?
- A. Auto-RP
- B. SSM
- C. BSR
- D. BID1R-PIM
Answer: C
NEW QUESTION 69
Refer to the exhibit:
P3 and PE4 are at the edge of the service provider core and serve as ABR routers Aggregation areas are on either side of the core.
Which statement about the architecture is true?
- A. To support seamless MPLS, the BGP route reflector feature must be disabled
- B. To support seamless MPLS. TDP must be used as the label protocol
- C. If each area is running its own IGP. BGP must provide an end-to-end MPLS LSP
- D. If each area is running its own IGP. the ABR routers must redistribute the IGP routing table into BGP
Answer: C
NEW QUESTION 70
Which two IS-IS parameters must match before two level 2 peers will form an adjacency? (Choose two.)
- A. area ID
- B. authentication settings
- C. MTU
- D. system ID
- E. hello timer setting
Answer: B,C
NEW QUESTION 71
Refer to the exhibit. Which additional configuration must an engineer to the adge router to inject a default router into the MP-BGP address family for the internet_Shared_Services dedicated VRF?
A)
B)
C)
D)
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: B
NEW QUESTION 72
Which two uses of the YANG data modeling language are true? (Choose two)
- A. It can be used to model the configuration used by NETCONF operations
- B. It can be used to access a device by HTTP
- C. It can be used to replace RESTCONF as a mechanism to install and manipulate configuration
- D. It can be used to shape slats data of network elements
- E. It can be used to replace the OSI model for troubleshooting
Answer: B,D
NEW QUESTION 73
You are testing the capabilities of MPLS OAM ping.
Which statement is true?
- A. An LSP is not required for the reply to reach the ingress MPLS router
- B. MPLS OAM ping works solely with P2P LSPs
- C. MPLS OAM ping works solely with Cisco MPLS TE
- D. An LSP breakage results in the ingress MPLS router never receiving any reply
Answer: D
NEW QUESTION 74
Drag and drop the multicast concepts from the left onto the correct descriptions on the right.
Answer:
Explanation:
Explanation
1: PIM-DM 2:IGMP 3:PIM-SM 3:shared tree 4:source tree
NEW QUESTION 75
Refer to the exhibit:
Export statistics received do not include the BGP next hop.
Which statement about the NetFlow export statistics is true?
- A. The origin AS and the peer-as will be included in the export statistics
- B. Loopback 0 must be participating in BGP for it to be included in the export statistics
- C. To include the BGP next hop in the export statistics, those keywords must be included with the version
9 entry. - D. Only the origin AS of the source router will be included in the export statistics.
Answer: A
NEW QUESTION 76 
Refer to the exhibit. Router 1 is missing the route for the router 2 loopback 0. What should the engineer change to fix the problem?
- A. the hello timers on Router 1 and Router 2 to be different
- B. the area numbers on Router 1 and Router 2 to be similar
- C. the wildcard mask network statement in OSPF of Router 2
- D. Router 1 to be an ABR
Answer: B
Explanation:
Section: Networking
NEW QUESTION 77
Which statement describes the advantage of a Multi-Layer control plane?
- A. It automatically provisions, monitors, and manages traffic across Layer 0 to Layer 3.
- B. It provides multivendor configuration capabilities for Layer 3 to Layer 1.
- C. It supports dynamic wavelength restoration in Layer 0.
- D. It minimizes human error configuring converged networks.
Answer: B
Explanation:
Section: Architecture
NEW QUESTION 78
Refer to the exhibit.
A network engineer is implementing a standard customer route-policy on router ASBR1 with these requirements:
* it must accept only customer-assigned prefixes.
* It must preserve customer-advertised BGP communities.
* it must set the local-preference to no for all prefixes.
* it must attach the ORIGINATION-PE and LOCAL-CITY communities to an accepted prefixes.
Which route policy must the engineer implement on ASBR1 to satisfy the requirements?
A)
B)
C)
D)
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: B
NEW QUESTION 79
Refer to the exhibit:
A network engineer is implementing a BGP protocol. Which effect of the locat-as keyword in this configuration is true?
- A. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 and the VPNv4 address family
- B. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 and the VPNv4 address family
- C. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 without additional configuration.
- D. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 without additional configuration
Answer: C
NEW QUESTION 80
Refer to the exhibit.
A network operator needs to shut down interface Gi0/0/0/2 for maintenance. What occurs to the interface states of Gi0/0/0/0 and Gi0/0/0/1?
- A. Gi0/0/0/0 becomes active. Gi0/00/1 remains standby
- B. Gi0/0/0/1 and Gi0/0/0/0 become active
- C. Gi0/0/0/1 and Gi0//0/0 remains standby
- D. Gi0/0/0/1 becomes active Gi0/0/0/0 remains standby
Answer: A
NEW QUESTION 81
What is a role of NSO?
- A. It automates the deployment of access points with its built-in wireless LAN controller.
- B. It provides full lifecycle management of a device.
- C. It manages WAN infrastructure using a virtual switch.
- D. It resides on a hypervisor that runs the Windows OS.
Answer: B
NEW QUESTION 82
Refer to the exhibit:
R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed. When the debug ip ospf hello command is issued on R1. these log messages are seen.
Which command can be configured on routers R1 and R2 on fO/O interfaces to form OSPF adjacency?
- A. ip ospf network point-to-point
- B. ip ospf network point-to- multipoint non-broadcast
- C. ip ospf network non-broadcast
- D. ip ospf network broadcast
Answer: A
NEW QUESTION 83 
Refer to the exhibit. Which command is used to complete this configuration for QoS class-based marking?
- A. PE-A(config-pmap-c)#fair-queue
- B. PE-A(config-pmap-c)#set dscp ef
- C. PE-A(config-pmap-c)#random-detect
- D. PE-A(config-pmap-c)#priority
Answer: B
Explanation:
Section: Services
NEW QUESTION 84
......
Valid Way To Pass Cisco's 350-501 Exam with : https://www.actualtorrent.com/350-501-questions-answers.html
Free Test Engine For Implementing and Operating Cisco Service Provider Network Core Technologies Certification Exams: https://drive.google.com/open?id=1K8I0KxyfTe1s_LeS-SQARYBJKD_66nTr