Updated Mar-2023 100% Cover Real JN0-250 Exam Questions Make Sure You 100% Pass
JN0-250 dumps Accurate Questions and Answers with Free and Fast Updates
NEW QUESTION 11
You are troubleshooting a signal strength issue when you notice that the signal strength changes from -70 to -73 dBm as you move from one room to another.
In this scenario, what is happening?
- A. Signal strength has decreased by 10x.
- B. Signal strength has increased by 10x.
- C. Signal strength has halved.
- D. Signal strength has doubled.
Answer: A
NEW QUESTION 12
Marvis requires which subscription?
- A. Virtual Network Assistant
- B. Premium Analytics
- C. Wired Assurance
- D. Asset Visibility
Answer: A
NEW QUESTION 13
You configured an 802.11n AP to use the 2.4 GHz frequency band and 20 MHz channel width.
In this scenario, how many non-overlapping channels are available for clients to use in Europe?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 14
Which statement is correct about 802.11 wireless network interfaces?
- A. Wireless NICs process all frames that are heard.
- B. Wireless NICs operate in full-duplex mode.
- C. Wireless NICs use Carrier Sense Multiple Access Collision Detection.
- D. A wireless NIC only receives frames destined for it.
Answer: C
NEW QUESTION 15
A microwave oven would be classified as which type of interference?
- A. rogue
- B. Wi-Fi
- C. non Wi-Fi
- D. security
Answer: C
NEW QUESTION 16
You have discovered an access point that is not connected to the corporate network but it broadcasts the corporation's SSID.
In this scenario, what is this type of access point called?
- A. rogue
- B. neighbor
- C. honeypot
- D. air gap
Answer: B
NEW QUESTION 17
A user is experiencing DNS problems.
In this scenario, where in the GUI would you be able to see the problems?
- A. Insights
- B. Live View
- C. Clients tab
- D. WLAN tab
Answer: A
NEW QUESTION 18
Which Juniper Mist device enables seamless roaming for large campus networks through on-premises tunneling?
- A. Mist Edge
- B. Mist AP43
- C. Mist BT11
- D. Mist AP33
Answer: A
NEW QUESTION 19
You have just brought online a new site of AP43s. While verifying that everything looks good, you notice that all of the access points (APs) are reporting "insufficient power." The APs are connected to an 802. 3at-capable switch.
In this scenario, what would be the cause of the error?
- A. The Ethernet cable is plugged into the wrong port on the AP.
- B. LLDP-MED is not configured on the switch.
- C. The APs' firmware must be upgraded.
- D. The cable run to each AP is too long.
Answer: C
NEW QUESTION 20
Which statement is correct about a WLAN RF medium?
- A. A WLAN RF is a full duplex, contention free medium where each client transmits on a separate channel.
- B. A WLAN RF is a full-duplex, contention-free medium where 802.11 stations can transmit and receive at the same time.
- C. A WLAN RF is a half-duplex, shared medium where 802.11 stations contend with each other for access.
- D. A WLAN RF is a half-duplex, contention-free medium where the access point polls each station in turn.
Answer: C
NEW QUESTION 21
What are two characteristics of the 2.4 GHz band when compared to the 5 GHz band? (Choose two.)
- A. shorter wavelength
- B. less non-Wi-Fi interference
- C. lower frequency
- D. more congestion
Answer: C,D
NEW QUESTION 22
Which Mist subscription is required for location tracking of Bluetooth badges?
- A. Virtual Network Assistant
- B. Asset Visibility
- C. Wi-Fi Assurance
- D. User Engagement
Answer: B
NEW QUESTION 23
Which Mist device is designed exclusively for Bluetooth Low Energy?
- A. AP63
- B. AP12
- C. AP43
- D. BT11
Answer: D
NEW QUESTION 24
You are designing a wireless network that requires smooth roaming performance and redundant coverage from at least two access points at every location.
What ensures that both of these functional requirements are satisfied?
- A. co-channel interference
- B. secondary coverage
- C. data rate
- D. primary coverage
Answer: C
NEW QUESTION 25
What does 802.11ac (Wi-Fi 5) specify as the maximum channel width?
- A. 40 MHz
- B. 20 MHz
- C. 160 MHz
- D. 60 MHz
Answer: C
NEW QUESTION 26
What are two characteristics of the 2.4 GHz band when compared to the 5 GHz band? (Choose two.)
- A. shorter wavelength
- B. lower frequency
- C. less non-Wi-Fi interference
- D. more congestion
Answer: B,C
NEW QUESTION 27
You are configuring your Mist network and you want to separate certain users into their own networks and VLANs. You are concerned about the network's utilization and want to make sure that only a single SSID is sending beacons.
In this scenario, which feature would accomplish this behavior?
- A. virtual SSID
- B. SSID scheduling
- C. multiple PSK
- D. geofence
Answer: C
NEW QUESTION 28
Which statement is correct about the default configuration of a Mist AP?
- A. 192.168.0.1 is statically configured on the uplink port.
- B. No interface configuration is provided and an IP must be statically defined after booting.
- C. VLAN tagging is enabled.
- D. DHCP is enabled to retrieve IP information.
Answer: A
NEW QUESTION 29
Which statement is correct about the Mist API?
- A. Only SLE configurations are available from the API.
- B. Everything seen in the GUI is available from the API.
- C. Only AP configurations are available from the API.
- D. Nothing seen in the GUI is available from the API.
Answer: C
NEW QUESTION 30
When using the Mist Cloud with Mist APs, which statement is correct?
- A. User data is compressed and terminated in the cloud.
- B. User data is terminated in the cloud and run through a firewall.
- C. User data is terminated in the cloud and forwarded.
- D. User data is bridged locally.
Answer: D
NEW QUESTION 31
Which organization is responsible for certifying that products and technology satisfy Wi-Fi interoperability?
- A. ISO
- B. IEEE
- C. Wi-Fi Alliance
- D. IETF
Answer: C
NEW QUESTION 32
You have designed a WLAN to satisfy primary coverage, secondary coverage, and capacity requirements.
However, you still do not have enough BLE radios to satisfy your location requirements. You want to fill the gaps with a low cost, BLE-only device.
Which Mist device will satisfy this requirement?
- A. AP43
- B. AP32
- C. AP41
- D. BT11
Answer: D
NEW QUESTION 33
Which underlying technology does Mist use to calculate BLE location?
- A. time of flight
- B. triangulation
- C. probability surface
- D. trilateration
Answer: C
NEW QUESTION 34
When would be the earliest opportunity to configure an access point (AP)?
- A. after the AP is online
- B. after the AP is claimed to inventory
- C. after you are on the same network as the AP
- D. after the AP is installed
Answer: D
NEW QUESTION 35
What does 802.11ac (Wi-Fi 5) specify as the maximum channel width?
- A. 40 MHz
- B. 20 MHz
- C. 160 MHz
- D. 60 MHz
Answer: C
Explanation:
Reference:
%20configuration%202x2%20and%20above
NEW QUESTION 36
......
Real JN0-250 Quesions Pass Certification Exams Easily: https://www.actualtorrent.com/JN0-250-questions-answers.html