2022 Valid NSE7_SDW-6.4 test answers & Fortinet Exam PDF [Q19-Q40]

2022 Valid NSE7_SDW-6.4 test answers & Fortinet Exam PDF

Free Fortinet NSE7_SDW-6.4 Exam Questions and Answer from Training Expert ActualTorrent

Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:

Topic	Details
Topic 1	Configure SD-WAN rules Troubleshoot VPN and ADVPN
Topic 2	Troubleshoot central management problems Troubleshoot SD-WAN
Topic 3	Central management Configure SD-WAN SLAs
Topic 4	Implement a full or partially meshed redundant VPN infrastructure SD-WAN configuration

NEW QUESTION 19
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )

A. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
B. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
C. It acts as a policy compliance entity to review all managed FortiGate devices.
D. It improves SD-WAN performance on the managed FortiGate devices.
E. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.

Answer: C,D

NEW QUESTION 20
Refer to the exhibit.

What must you configure to enable ADVPN?

A. ADVPN should only be enabled on unmanaged FortiGate devices.
B. Each VPN device has a unique pre-shared key configured separately on phase one
C. The protected subnets should be set to address object to all (0.0 .0. o/o).
D. On the hub VPN, only the device needs additional phase one sett

Answer: B

NEW QUESTION 21
Refer to the exhibit.

Which statement about the trace evaluation by FomGate is true?

A. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
B. The packet exceeded the configured bandwidth and was dropped based on the priority configuration
C. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
D. Packets exceeding the configured concurrent connection limit are dropped based on tfte priority configuration.

Answer: D

NEW QUESTION 22
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)

A. The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces
B. SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom
C. The implicit rule overrides all other rules because parameters widely cover sources and destinations.
D. The initial session of an application goes through a learning phase in order to apply the correct rule

Answer: C,D

NEW QUESTION 23
Which statement is correct about the SD-WAN and ADVPN?

A. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
B. ADVPN interface can be a member of SD-WAN interface.
C. Dynamic VPN is not supported as an SD-Wan interface.
D. Spoke support dynamic VPN as a static interface.

Answer: C

NEW QUESTION 24
Refer to the exhibit.

Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)

A. set source 100.64.1.1.
B. set priority 10.
C. set cost 15.
D. set load-balance-mode source-ip-based.

Answer: B,D

NEW QUESTION 25
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

A. Interface-based shaping mode
B. Reverse policy shaping mode
C. Per-IP shaping mode
D. Shared policy shaping mode

Answer: A

NEW QUESTION 26
Refer to exhibits.
Exhibit A.

Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output Based on the exhibits, which statement is correct?

A. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
B. Port1 became dead 1ecause no traffic was offload through the egress of port1.
C. SD-WAN member interfaces are affected by the SLA state of the inactive interface
D. Both SD-WAN member interfaces have used separate SLA targets.

Answer: D

NEW QUESTION 27
Refer to exhibits.

Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)

A. All the existing sessions will continue to use port2, and new sessions will use port1.
B. All the existing sessions will be blocked from using port1 and port2.
C. All the existing sessions that do not use SNAT will be flushed and routed through port1.
D. All the existing sessions using SNAT will be flushed and routed through port1.

Answer: A,D

NEW QUESTION 28
Which three parameters are available to configure SD-WAN rules? (Choose three.)

A. Source and destination IP address
B. URL categories
C. Internet service database (ISDB) address object
D. Type of physical link connection
E. Application signatures

Answer: A,B,C

NEW QUESTION 29
Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

A. Set cost 15.
B. Set load-balance-mode source-ip-ip-based.
C. Set source 100.64.1.1.
D. Set priority 10.

Answer: C

NEW QUESTION 30
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?

A. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
B. Check interval is the time to wait before a packet sent by a member interface considered as lost.
C. The dead member interface stays unavailable until an administrator manually brings the interface back.
D. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.

Answer: D

NEW QUESTION 31
Refer to the exhibit.

What must you configure to enable ADVPN?

A. ADVPN should only be enabled on unmanaged FortiGate devices.
B. The protected subnets should be set to address object to all (0.0.0.0/0).
C. Each VPN device has a unique pre-shared key configured separately on phase one.
D. On the hub VPN, only the device needs additional phase one settings.

Answer: C

Explanation:
Explanation/Reference:

NEW QUESTION 32
Refer to exhibits.

Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?

A. Port1 became dead 1ecause no traffic was offload through the egress of port1.
B. Both SD-WAN member interfaces have used separate SLA targets.
C. SD-WAN member interfaces are affected by the SLA state of the inactive interface
D. The SLA state of port1 is dead after five unanswered requests by the SLA servers.

Answer: D

NEW QUESTION 33
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?

A. diagnose sys virtual-wan-link health-check
B. diagnose sys virtual-wan-link log
C. diagnose sys virtual-wan-link sla-log
D. diagnose sys virtual-wan-link intf-sla-log

Answer: C

Explanation:
Explanation/Reference: https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/943037/sla-logging

NEW QUESTION 34
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers. The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links. One link has random jitter and latency issues, and is based on a wireless connection.
Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD-WAN rules? (Choose two.)

A. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.
B. Choose the suitable interface based on the interface cost and weight.
C. Place the troublesome link at the top of the interface preference list.
D. Configure an SD-WAN rule to load balance all traffic without VoIP.
E. Use the performance SLA targets to detect latency and jitter instantly.

Answer: A,E

NEW QUESTION 35
Which statement reflects how BGP tags work with SD-WAN rules?

A. VPN topologies are formed using only BGP dynamic routing with SD-WAN
B. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
C. BGP tags match the SD-WAN rule based on the order that these rules were installed.
D. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces

Answer: A

NEW QUESTION 36
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?

A. Choose the suitable interface based on the interface cost and weight
B. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule
C. Configure an SD-WAN rule to load balance all traffic without VoIP
D. Place the troublesome link at the top of the interface preference list.
E. Use the performance SLA targets to detect latency and jitter instantly.

Answer: A,E

NEW QUESTION 37
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )

A. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub
B. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links
C. It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance
D. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.

Answer: A,B

NEW QUESTION 38
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?